Luna Light Acrylic Gel 02 30ml

LIQUID GEL LIGHT ACRYGEL is an innovative material for strengthening, smoothing, and lengthening nails. It is a symbiosis of polygel and base. It consists of 60–80% acrylic copolymer (the main component of polygel) and a small amount of hydroxyethyl methacrylate (approximately 20–30%), the main component of base coats. Such a gel can completely replace the base.

Features:

• The wavelength for polymerization is 365–405 nm.
• The power of the UV/LED lamp is 36-48 W.
• The permissible thickness of the coating is 0.5 mm at the edge of the nail, 1 mm at the tip.
• Acid-free, has a medium consistency.
• It has medium pigmentation, overlaps the free edge.
• Complete polymerization takes place in 120 seconds.
• Suitable only for strengthening the nail and additional extensions.
• It has good cushioning.
• If you strengthen with this gel, you will need to cut out a natural nail.
• Requires a rubber pad .
• It can be heated further to make the gel thinner.

Type of application:

STRENGTHENING

1. Distance.
2. We do not file the shape of the nail and do not leave it 2 mm long, which we remove after alignment.
3. Using a 220 grit file, we apply a fine dusting of the nail from above, without applying excessive pressure, by lifting the scales of the nail plate, or use a 100 grit buff.
4. We do a manicure.
5. When working with removers, wash your hands with soap and water after use.
6. Degrease the nail with Nail Prep LUNAmoon . We follow two approaches. We use four wipes (one for five fingers). The first approach: Wipe the surface of the nail. The second approach: Take an orange stick, place a wipe on it, and wipe everything in the cuticle area and sinuses.
7. We use primer as desired, but if the base for the substrate has sufficient acidity, it is not needed.
8. The LUNAmoon Rubber Base The back is best applied with a flat gel brush. The movements should be rubbing. We line all the sinuses of the nail and dry them in a lamp for 60 seconds.
9. Eliminate stickiness.
10. Alignment. When aligning with a gel, we make a 0.5 to 1 mm indentation in the cuticle. Let it dry under a lamp for 60 seconds.
11. After leveling, we file the shape. This is necessary to create a thickness at the edge of the nail that will hold the free edge.
12. If the nail was thin, it may curl, so be sure to trim 1 mm of natural nail from the inside. In this case, the material won't peel off. If the material is hard and the nail is very soft, the nail itself will begin to peel off the hard material from the free edge.
13. After sawing, wipe off the stickiness and cover with gel polish.
14. Cover with top. Let it dry for 120 seconds. Do not wipe with anything after drying, as this may cause the shine to disappear.

CLASSIC EXTENSION

1. distance
2. We reduce the length of the nail to 1 mm and make a round shape.
3. Using a 220 grit file, we apply a fine dusting of the nail from above, without applying excessive pressure, by lifting the scales of the nail plate, or use a 100 grit buff.
4. We do a manicure.
5. When working with removers, wash your hands with soap and water after use.
6. Degrease the nail with Nail Prep LUNAmoon . We follow two approaches. We use four wipes (one for five fingers). The first approach: Wipe the surface of the nail. The second approach: Take an orange stick, place a wipe on it, and wipe everything in the cuticle area and sinuses.
7. We use the LUNAmoon primer .
8. The LUNAmoon Rubber Base The back is best applied with a flat gel brush. The movements should be rubbing. We line all the sinuses of the nail and dry them in a lamp for 60 seconds.
9. Eliminate stickiness.
10. Install a form to build up the free edge of the nail.
11. Apply a clear gel to the shape of an artificial nail. Let it dry for 30 seconds.
12. We file the free edge and give the nail the desired shape.
13. Wipe off any stickiness and excess dust.
14. Let's go through the Rubber Base LUNAmoon Go over the areas where the saw was used again. Let it dry for 30 seconds.
15. Align with gel, insert a light, and clamp for 10-15 seconds. If the gel is very sticky or contains glitter, clamp at the 20th second mark.
16. Let it dry in the lamp for 120 seconds.
17. Wipe off any stickiness before coating with gel polish.
18. Cover with top. Let it dry for 120 seconds. Do not wipe with anything after drying, as this may cause the shine to disappear.

Product shelf life: 24 months. Do not store for longer than 18 months.

TPO FREE(
Product photos on the website may differ from the actual product)